cornerhardware.com your home for home improvement
Shop over 40,000 Products online
Home Log In Privacy Notice Contact Us
CornerHardware.com Electrical Supplies Winter Specials - click here
Blinds Building Materials Electrical Gifts Hand Tools Hardware Heating & Coooing Housewares Kitchen & Baths Lawn & Garden Lighting Paint & Supplies Plumbing Powertools
Building Materials->Electrical->GiftsHand Tools->Hardware->Heating & Cooling->Housewares->Kitchen & Bath->Lighting->Paint & Supplies->Plumbing->Powertools->Lawn & Garden->
  Discount Corner  
  Lg Deerskin Palm Glove
Lg Deerskin Palm Glove
$9.36
 
     

How to Replace a Faucet

If your faucet is funky, leaky or impossibly dowdy replace it. It's an easy repair, and it doesn't cost all that much unless you're going for the 24-carat model. And, along the way, you'll meet one of the cleverest tools ever to tighten a nut the basin wrench.

Step by Step

1. Clear space below the sink and turn off the water by turning the angle stops clockwise. Open the faucets to drain water in the lines. There's always a little water left, however, so have a sponge and bucket handy.

2. Remove the old faucet. Crawl under the sink and look up at the underside of the set-up. You'll see hot and cold supply tubes connected to nuts on the underside of each faucet stem. To loosen those nuts voila! the basin wrench. As you'll see in the animation, you loosen the nuts by turning the wrench counterclockwise. Also disconnect the drain pop-up lever, which will be fastened with a setscrew or a spring clip you squeeze to release.

3. Push the supply tubes aside, and use the basin wrench to remove the locknuts on each side of the faucet. Once on your feet again, lift the old faucet out and clean away any crud that has accrued over the years. If the old faucet was seated in plumber's putty or a gasket, for example, use a putty knife to clean up the surface.

4. Install the new faucet. Following the manufacturer's instructions, use your basin wrench to tighten down the new faucet. Have a friend hold the faucet in place so it doesn't get cockeyed while you tighten it from below.

5. Reattach supply tubes. If your supply tubes aren't stainless-steel-jacketed flexible supply tubes, now's the time to add them. They're inexpensive, far superior to solid copper or flexible plastic, and easy to connect and disconnect. Besides, old lines often drip when reattached.

6. To finish, sponge up any dribbled water, reconnect the drain pop-up, turn on the angle stops, remove the faucet aerator, and run the water, hot and cold, to flush out the lines. This eliminates any loose pipe scale that may be present. When the water runs clear, replace the aerator and enjoy your new faucet.

CornerHardware.com recommended tools & supplies:

  • Pipe Wrenches

  • Basin Wrench

  • Putty Knife

  • Faucet/Supply Tube Shank Nut

  • Adjustable Style Handle Flange

  • Bevel Washer

  • Flat Washer

  • Handle Screws

  • Delta Repair Kit


  • Little Giant Type 1A Ladder
    Plan3D.com



    search all products:
     
    corner hardware view my cart
    Seasonal Deals
    Semiautomatic Powder Actuated Fastening Tool
    Semiautomatic Powder Actuated Fastening Tool
    $328.13
     

    LINKS!

    www.ifloor.com
    www.rugarea.com
    www.naturalcupboard.com


    Bookmark CornerHardware.com - Your Home for Home Improvement
    Copyright 2007 and All Rights Reserved by CornerHardware.com